Toyota Celica Supra 1986 Service And Repair Manual page 675

80·6
BODY -Front Door
INSTALLATION OF FRONT OOOR
(See- 80·3)
1. BEFORE INSTALLING PARTS COAT THEM WITH
MP GREASE
(a) Coat the sliding surface and gears with MP grease.
(b) Coat the sliding surface with MP grease.
2. INSTALL OOOR LOCK AND SOLENOID WITH
MOUNTING SCREWS
3. INSTALL OUTSIDE HANDLE
4. INSTALL INSI DE HANDLE
5. CONNECT FOLLOWING LINKAGES:
(a) Outside control link
(b) Door lock control link
(c) Door lock cylinder link
(d) Door open control link
6. ADJUST DOOR INSIDE HANDLE
(a) Loosen the screws.
(b) Push the door handle forward until strong resistance
is felt. Move handle back 0.5 - 1.0 mm (0.020 -
0.039 in.) and tighten the mounting bolts.
7. ADJUST DOOR INSIDE LOCK
(a) Loosen the adjusting bolt.
(b) Push the door lock adjusting bolt upward until strong
resistance is felt. Mova the bolt down 0.5 - 1.0 mm
(0.020 - 0.039 in.) and tighten the bolt.