Toyota Celica Supra 1986 Service And Repair Manual page 84

EM-62 ENGINE MECHANICAL - Cylinder Block
1 111431
10. INSTALL COOLANT RESERVOIR TANK
11 . INSTALL RADIATOR
(a) Install the radiator and the two mount. i ng bolts.
(b) Connect the coolant receiver tube.
(c) Connect the two oil cooler hose. lfor AfT)
(d) Install the radietor lower hose .
12. INSTALL FAN SHROUD AND FLUID COUPLING
13. INSTALL AIR CLEANER CASE, AIR FLOW METER AND
AIR
INTAKE CONNECTOR PIPE
14. CONNECT EFI WIRE HARNESS TO ECU
15. CONNECT TWO HEATER HOSES TO BLOCK AND
CYLINDER HEAD
16. CONNECT FOLLOWING HOSES:
(&)
Brake booster vacuum hose to the intake manifold
(b) ActuatOI' vacuum hose to the intake manifold (with
cruise control system)
(c)
EGR
valve vacuum hose
17. CONNECT FOLLOWING WIRES AND CABLES:
(a)
Ground to the cylinder heed
(b)
Oxygen sensor wire
(c)
Oil pressure sending unit wire
(d) ECT
connectors
(e)
High·tension cord from the ignition coil
(II
Distributor connector
(g) Water temp. sending unit w ire
(h) Temp. switch wire
(for A/Tl
(i)
Solenoid resistor wire connector
(j)
Knock sensor wire connector
1B. INSTALL ACCELERATOR AND ACTUATOR CABLE
BRACKET
19 . INSTALL THROTTLE CABLE BRACKET (for AITI
20. FILL WRH COOLANT
Close the radiator and engine drain coc::ks and
fill with
coolant.
Total capacity: w/Heater
MIT 8.0 Nters IB.5 US qta. 7.0 Imp. qtal
AfT 7.9 liters 18.3 US qla, 7.0 Imp. qui