Toyota Celica Supra 1986 Service And Repair Manual page 59

I
I
I
ENGINE MECHANICAL - Cylinder Head
EM·37
OU4J1
..
...,
26. CONNECT FOLLOWING HOSES:
fa) EGA vacuum hose
(b) Fuel hose
(c) Actuator vacuum hose
Cdl Brake booster vacuum hose
26. CONNECT FOLLOWING WIRES AND CABLES:
fa)
Distributor coonector
(b) High·tenslon cord from the Ignition
coil
(C)
Oxygen sensor wire connector
(d)
Ground strap to cylinder head cover
fel
Temp. switch w ire (lor A/TI
(f)
Solenoid resistor wire connector
(g)
Knock sensor wire connector
27. INSTALL ACCELERATOR AND ACTUATOR
BRACKET TO CYLINDER HEAD COVER
CABLE
28.
INSTALL THROTTLE CABlE BRACKET TO CYLINDER
29.
HEAD COVER
(lor
AJT)
FILL WITH COOLANT
Close the radiator and engine drain cocks and fill with
coolant.
Total capacity: Dry fll
MIT 8.0 litera (8.6 US qts, 7.0 Imp. qtsl
A/T 7.91itera (8.3 US qts, 7.0 Imp. qtsl
30.
CONNECT CABLE TO NEGATIVE TERMINAL OF BATTERY
31. START ENGINE
Warm up the engine and check for leaks.
32.
PERFORM ENGINE ADJUSTMENT
fa) Recheck the ignition timing. (See page IG -10)
lbl Retighten the cylinder head bolts.
!See step
3 on page EM·341
33. ROAO TEST
Perform a road test.
34. RECHECK COOLANT AND ENGINE OIL LEVEL