Toyota Celica Supra 1986 Service And Repair Manual page 262

MT-22
MANUAL TRANSMISSION - W 58 Transmission
5. INSTALL SECOND GEAR AND NO. 1 CLUTCH HUB
(a) Apply gear oil to the shaft and needle roller bearing.
(b) Place the synchronizer ring on the gear and align the
ring slots with the shifting keys.
lc) Install the needle roller bearing in the 2nd gear.
(d) Using a press, install the 2nd gear and No. 1 clutch
hub.
6. INSTALL LOCKING BALL AND FIRST GEAR ASSEMBLY
Ia) Install the locking ball in the shaft.
lbl Apply gear oil to the bearing.
I c) Assemble the 1st gear, synchronizer ring, needle roller
bearing and bearing inner race.
ld) Install the assembly on the output shaft with the syn·
chronizer ring slots aligned with the shifting keys and ·
turn the inner race to align
it
with the locking ball,
7. INSTALL OUTPUT SHAFT CENTER BEARING
Using SST and a press, install the bearing on the output
shaft with the outer race snap ring groove toward the rear.
NOTE: Hold the 1st gear inner race to prevent it from
falling.
SST 09506-35010