Toyota Celica Supra 1986 Service And Repair Manual page 229

CHARGING SYSTEM - Alternator CH·11
5. INSTALL BRUSH HOLDER AND IC REGULATOR
(a) Place the brush holder cover to the brush holder.
(b) Install the IC regulator and brush holder to the rear
end frame horizontally as shown in the figure.
NOTE: Make sure the brush holder's cover doesn't slip
to one side during installation.
(c) Install and tighten the three screws.
NOTE : Make sure the gap between the brush holder and
connector is at least
1
mm
(0.04
in.).
6.
INSTALL REAR ENO COVER
(a) Install the end cover with the three nuts.
(b) Install the terminal insulator with the nut.
INSTALLATION OF ATERNATOR
1 .
INSTALL ALTERNATOR
Mount the alternator on the engine bracket with the pivot
and adjusting lock bolts.
Do not tighten the bolts.
2.
INSTALL DRIVE BELT
(a) Install the drive belt.
L-- - - - - - - -- - -...: - = •
(b) Using
a
belt tension
gauge,
check the drive belt
tension.
(See
page CH·3)
3. CONNECT WIRING TO ALTERNATOR
(a) Connect the wire to the alternator and install the nut.
(b) Connect the connector to the alternator.
4 . CONNECT NEGATIVE CABLE TO BATTERY
5.
PERFORM ON·VEH ICLE INSPECTION
(See
pages CH·2 to
4 )