Ip Igmp Limit - Allied Telesis x510-28GTX Command Reference Manual

IGMP IGMP S C
AND NOOPING OMMANDS

IP IGMP LIMIT

ip igmp limit
Overview Use this command to configure the limit on the maximum number of group
membership entries for the device as a whole or for the specified interface (if in
interface mode). Once the specified number of group memberships is reached, all
further membership reports will be ignored.
Optionally, you can configure an access-list to stop certain addresses from being
subject to the limit.
Use the no variant of this command to unset the limit and any specified exception
access-list.
ip igmp limit <limit-value> [except
Syntax
{<access-list-number>|<access-list-number-extended>|
<access-list-name>}]
no ip igmp limit
Default The default limit, which is reset by the no variant of this command, is 512.
Mode Global Configuration and Interface Configuration for a VLAN interface.
Usage This command applies to VLAN interfaces configured for IGMP, IGMP Snooping, or
IGMP Proxy.
Example To configure an IGMP limit of 100 group membership entries on vlan2, use the
commands:
awplus#
awplus(config)#
awplus(config-if)#
To configure an IGMP limit of 100 group membership entries across all interfaces
on which IGMP is enabled, and exclude group 224.1.1.1 from this limitation, use
the commands:
awplus#
awplus(config)#
awplus(config)#
C613-50170-01 Rev B
Parameter
<limit-value>
<access-list-number>
<access-list-number-extended> Access-list number (expanded range), in
<access-list-name>
configure terminal
interface vlan2
configure terminal
access-list 1 permit 224.1.1.1 0.0.0.0
ip igmp limit 100 except 1
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
Maximum number of group membership
entries, from 2 to 512.
Access-list number, in the range 1 to 99.
the range 1300 to 1999.
IP access-list name.
ip igmp limit 100
1202