Security and authentication
11.1 User management
11.1.2
change password
Description
With this command, you change the password of the logged in user.
Requirement
● You are logged into the device with a local user account
● You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
change password <passwd>
The parameter has the following meaning:
Parameter
passwd
Result
The password is changed.
Note
Changing the password in Trial mode
Even if you change the password in Trial mode, this change is saved immediately.
Further notes
You create a user with the
You delete a user with the
You show the created users with the
678
or
cli#
Description
Value for the password
user-account
no user-account
Range of values / note
Enter the password.
The password must meet the following
password policies:
Password length: at least 8 characters
•
At least 1 uppercase letter
•
At least 1 special character
•
At least 1 number
•
command.
command.
command.
show user-accounts
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10