The "Show" Commands; Show Fmp Limit; Show Fmp Status - Siemens SCALANCE XM-400 Configuration Manual

Industrial ethernet switches

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

The "show" commands

This section describes commands with which you display various settings.

This command shows the limit values for the received power and the power loss that you set

for monitoring optical ports or connections with fiber monitoring.

You are in the User EXEC mode or in the Privileged EXEC mode.

The command prompt is as follows:

Call up the command with the following parameters:

show fmp limit [{interface <interface-type> <interface-id>}]

The parameters have the following meaning:

interface-type

interface-id

For information on identifiers of addresses and interfaces, refer to the section "Interface

identifiers and addresses (Page 39)".

If no parameters are specified, the settings for all interfaces are displayed.

The limits set for the received power and the power loss are displayed.

This command shows the current status and the current values of the optical ports or

connections that you monitor with fiber monitoring.

Keyword for a an interface description

Type or speed of the interface

Module no. and port no. of the interface

Range of values / note

Enter a valid interface.

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 11/2015, C79000-G8976-C252-10

Show Quick Links

Table of Contents

Scalance xr-500