Siemens SCALANCE XM-400 Configuration Manual page 705

Requirement
You are in the MAC ACL configuration mode.
The command prompt is as follows:
cli(config-ext-macl)#
Syntax
Call up the command with the following parameters:
deny {any|host<src-mac-address>}{any|host<dest-mac-address>}
The parameters have the following meaning:
Parameter
any
host
src-mac-address
any
host
dest-mac-address
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
Note
MAC address input
Use "any", if the rule is to apply to all src and/or dest MAC addresses. This corresponds to
the MAC address "00:00:00:00:00:00".
Result
The MAC access control list is configured.
Further notes
You exit the MAC ACL configuration mode with the
You delete the MAC access control list with the
You display the configuration of the access control list with the
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
Description
Keyword for "all"
Keyword for the MAC address of an
incoming connection that is locked
MAC address of the locked incoming
connection
Keyword for "all"
Keyword for the MAC address of an
outgoing connection that is locked
MAC address of the locked outgoing
connection
Security and authentication
11.3 MAC access control list
Range of values / note
-
-
Enter a valid MAC address
-
-
Enter a valid MAC address
command.
exit
no mac access-list extended
show access-lists
command.
command.
705