No Ipv6 Address Link-Local - Siemens SCALANCE XM-400 Configuration Manual

Network protocols
7.2 IPv6 protocol
Syntax
Call up the command with the following parameters:
ipv6 address <prefix> link-local
The parameter has the following meaning:
Parameter
prefix
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
Result
The link local address is assigned to the interface.
Further notes
You delete the link local address with the
You display this setting and other information with the
7.2.4.7

no ipv6 address link-local

Description
With this command, you delete the link local address.
Requirement
● IPv6 is activated
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
300
Description
Link local address
Range of values / note
Specify a valid link local address.
fe80::XXXX:XXXX:XXXX:XXXX
no ipv6 address link-local
show ipv6 interface
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
command.
command.