Reset And Defaults; Restart - Siemens SCALANCE XM-400 Configuration Manual

Configuration

3.3 Reset and Defaults

Syntax
Call up the command with the following parameters:
tftp server {ipv4 <ucast-addr> | fqdn-name <FQDN> | ipv6 <ip6_addr>} [port <tcp
port(1-65535)>]
The parameters have the following meaning:
Parameter
ipv4
ipv4-address
fqdn-name
FQDN
ipv6
ip6_addr
port
tcp port
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
Result
The settings for the access to the selected TFTP server are configured.
3.3 Reset and Defaults
This section describes commands for restarting the device and for restoring the original
configuration.
3.3.1

restart

Description
With this command, you restart the device.
Select one of the following configuration settings:
● Device restart with the current configuration
● Device restart with the factory configuration settings.
112
Description
Keyword for an IPv4 address
Value for an IPv4 unicast address
Keyword for a domain name
Domain name (Fully Qualified Domain
Name)
Keyword for an IPv6 address
Value for an IPv6 unicast address
Keyword for the port of the server via
which the TFTP connection runs
Number of the port
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Range of values / note
-
Enter a valid IPv4 unicast ad-
dress.
-
Maximum of 100 characters
-
Enter a valid IPv6 unicast ad-
dress.
-
1 ... 65535
Configuration Manual, 11/2015, C79000-G8976-C252-10