Vrrp Timer - Siemens SCALANCE XM-400 Configuration Manual

Syntax
Call up the command with the following parameters:
no vrrp <vrid(1-255)> priority
The parameters have the following meaning:
Parameter
vrid
Result
The priority is reset.
Further notes
You configure a VRRP3 interface with the
You create the priority with the
You assign IP addresses to a virtual router with the
You display the priority with the
9.5.5.13

vrrp timer

Description
With this command, you specify the time interval after which a virtual router with the "Master"
status sends an advertisement packet again.
Note
This command is available only with layer 3.
Requirement
● An IP address is assigned to the virtual router.
● You are in the VRRP3 Interface configuration mode.
The command prompt is as follows:
cli(config-vrrp-v3-if-$$$)#
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
Description
ID of the virtual router
interface
command.
vrrp priority
show vrrp3 interface - vrid
9.5 VRRPv3 (IPv4 / IPv6)
Range of values / note
1 ... 255
command.
command.
vrrp associated -ip
command.
Layer 3 functions
589