No Vrrp Primary-Ip - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.4 VRRPv2 (IPv4)
Syntax
Call up the command with the following parameters:
vrrp <vrid(1-255)> primary-ip <ip_addr>
The parameters have the following meaning:
Parameter
vrid
ip_addr
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
Result
The primary IPv4 address is specified.
Further notes
You configure a VRRP interface with the
You remove the primary IPv4 address with the
You show the configuration of the virtual router with the
command.
9.4.4.7

no vrrp primary-ip

Description
With this command, you remove an IPv4 address from the virtual router.
Note
This command is available only with layer 3.
Requirement
You are in the VRRP Interface configuration mode.
The command prompt is as follows:
cli (config-vrrp-if)#
562
Description
ID of the virtual router
Value for an IPv4 address
interface
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Range of values / note
1 ... 255
Enter a valid IPv4 address.
command.
command.
no vrrp pirmary-ip
show vrrp interface - vrid
Configuration Manual, 11/2015, C79000-G8976-C252-10