Commands In The Interface Configuration Mode; Ip Dhcp Relay Circuit-Id - Siemens SCALANCE XM-400 Configuration Manual

7.5.3

Commands in the Interface Configuration mode

This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
Global configuration mode.
● If you exit the Interface configuration mode with the
Privileged EXEC mode.
7.5.3.1

ip dhcp relay circuit-id

Description
With this command, you assign a Circuit ID to the interface.
Requirement
● The interface is an IPv4 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
ip dhcp relay circuit-id <circuit-id>
The parameter has the following meaning:
Parameter
circuit-id
Result
The Circuit ID is assigned.
Further notes
You remove the Circuit ID with the
You display the IP addresses with the
You display the settings with the
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
interface
Description
Circuit ID
no ip dhcp relay circuit-id
show dhcp server
show ip dhcp relay information
Network protocols
7.5 DHCPv4 Relay Agent (IPv4)
command to change to this mode.
command, you return to the
exit
command, you return to the
end
Range of values / note
1 ... 188
command.
command.
command.
329