Vrrp Preempt - Siemens SCALANCE XM-400 Configuration Manual

Industrial ethernet switches

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

Call up the command with the following parameters:

vrrp <vrid(1-255)> group shutdown

The parameter has the following meaning:

All IPv4 addresses of the group are removed.

Further notes

You configure a VRRP interface with the

You display the IPv4 addresses with the

vrrp preempt

With this command, you specify that a router with higher priority can take over the master

role from a router with lower priority.

This command is available only with layer 3.

● An IPv4 address is assigned to the virtual router.

● You are in the VRRP Interface configuration mode

.The command prompt is:

cli(config-vrrp-if)#

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 11/2015, C79000-G8976-C252-10

ID of the virtual router

show vrrp interface - vrid

9.4 VRRPv2 (IPv4)

Range of values / note

Layer 3 functions

Show Quick Links

Table of Contents

Scalance xr-500