No Area Range - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.3 OSPFv3 (IPv6)
9.3.3.5

no area range

Description
With this command, you delete the address range.
Note
This command is available only with layer 3.
Requirement
You are in the OSPFv3 router configuration mode.
The command prompt is as follows:
cli(config-ospfv3)#
Syntax
Call up the command with the following parameters:
no area <Area-ID> range
<IPv6-Prefix> / <Prefix-Length>
[{
advertise | not-advertise
}]
[
cost <cost>
]
The parameters have the following meaning:
Parameter
AreaID
IPv6-Prefix
Prefix-Length
advertise
not-advertise
cost
value
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
516
Description
Area ID
IPv6 address
Number of bits belonging to the prefix
(from left to right)
The address range is advertised outside the rang-
es.
The address range is not advertised to the outside. -
Keyword for the costs
Costs for the OSPF interface
Range of values / note
Specify the ID in the IPv4 address
format
x.x.x.x = 0 ... 255
0.0.0.0 = backbone area
Enter a valid IPv6 address
1 ... 128 bits
128: The node (host) itself
-
-
1 ... 65535
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10