9.3.3.18
router id
Description
With this command, you specify the ID of the router.
Note
This command is available only with layer 3.
Requirement
You are in the OSPFv3 router configuration mode.
The command prompt is as follows:
cli(config-ospfv3)#
Syntax
Call up the command with the following parameters:
router-id <IPv4-Address>
The parameter has the following meaning:
Parameter
IPv4-Address
Result
The ID of the router is specified.
Further notes
You display the router ID and other information with the
command.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
Description
Range of values / note
Router ID
Specify the ID in the IPv4 address format.
x.x.x.x
x = 0 ... 255
Layer 3 functions
9.3 OSPFv3 (IPv6)
show ipv6 ospf interface
531