6.3.4.3
spanning-tree compatibility
Description
With this command, you configure the compatibility version of the protocol that will be used
by the spanning tree function.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
spanning-tree compatibility {stp|rst|mst}
The parameters have the following meaning:
Parameter
stp
rst
mst
Result
The compatibility version of the protocol is selected.
Further notes
You can reset the setting to the default
command.
You can display the status of this function and other information with the
detail
You can display information about active ports with the
command.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
Description
The version is compatible with the
Spanning Tree protocol
The version is compatible with the
Rapic Spanning Tree protocol
The version is compatible with the
Multiple Spanning Tree protocol
command.
Range of values / note
-
Default: enabled
-
with the
mst
no spanning-tree compatibility
show spanning tree active
Network structures
6.3 Spanning Tree
show spanning tree
223