No Ipv6 Ospf - Siemens SCALANCE XM-400 Configuration Manual

Syntax
Call up the command with the following parameters:
ipv6 ospf area <IPv4-Address> [instance <instance-id>]
The parameters have the following meaning:
Parameter
IPv4-Address
instance
instance-id
Result
OSPFv3 on the interface is enabled.
Further notes
You configure the router ID with the
You disable OSPFv3 with the
You show the configuration of the OSPFv3 interface with the
command.
9.3.4.2

no ipv6 ospf

Description
With this command, you enable OSPFv3 on the interface.
Note
This command is available only with layer 3.
Requirement
● The interface is an IPv6 interface.
● The router ID is configured.
● OSPFv3 routing is activated.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
Description
IPv4 address of the interface with which the
OSPFv3 protocol instance is connected.
Keyword for the OSPFv3 protocol instance
ID of the OSPFv3 protocol instance
router id
no ipv6 ospf
Range of values / note
specify the IP address in the
IPv4 address format.
x.x.x.x
-
specify the ID in the IPv4 ad-
dress format
x.x.x.x
command.
command.
show ipv6 ospf interface
Layer 3 functions
9.3 OSPFv3 (IPv6)
533