Ripv2 (Ipv4); Show Ip Rip - Siemens SCALANCE XM-400 Configuration Manual

Syntax
Call up the command with the following parameters:
no vrrp <vrid(1-255)> timer <interval(50-4095)centiseconds>
The parameters have the following meaning:
Parameter
vrid
interval
Result
The time interval is reset.
Further notes
You configure a VRRP3 interface with the
You enable routing with VRRP3 with the
You configure the interval with the
You assign IP addresses to a virtual router with the
You show the interval with the
9.6

RIPv2 (IPv4)

This section describes the commands relevant for working with routing with RIPv2.
RIPv2 is only used with IPv4 and is defined in RFC 2453. It is based on the distance vector
algorithm of Bellman-Ford.
RIPv2 uses the UDP port 520.
9.6.1

show ip rip

Description
This command shows the RIP information.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
Description
ID of the virtual router
Time interval in hundredths of seconds
or
cli#
command.
interface
router vrrp3
command.
vrrp timer
vrrp associated -ip
show vrrp3 interface - vrid
Layer 3 functions
9.6 RIPv2 (IPv4)
Range of values / note
1 ... 255
50 ... 4095
command.
command.
command.
591