Commands In The Global Configuration Mode; Mac-Address-Table Block Static Multicast - Siemens SCALANCE XM-400 Configuration Manual

Layer 2 management protocols
8.6 Multicast
Syntax
Call up the command with the following parameters:
show mac-address-table static multicast[vlan<vlan-range>]
[address<aa:aa:aa:aa:aa:aa>][{interface<interface-type><interface-id>}]
The parameters have the following meaning:
Parameter
vlan
vlan-range
address
aa:aa:aa:aa:aa:aa
interface
interface-type
interface-id
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
If you do not select any parameter from the parameter list, the entries are displayed for all
available interfaces.
Result
The static multicast MAC addresses are displayed.
8.6.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
8.6.2.1

mac-address-table block static multicast

Description
With this command, you configure static multicast addresses that will be blocked.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
424
Description
Keyword for a VLAN connection
Number of the addressed VLAN
Keyword for a MAC address
MAC address
Keyword for a an interface description
Type or speed of the interface
Module no. and port no. of the interface
configure terminal
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Range of values / note
-
1 ... 4094
-
-
-
Enter a valid interface
command to change to this mode.
or command and are then in the
end exit
Configuration Manual, 11/2015, C79000-G8976-C252-10