No Ipv6 Dhcp Client Request - Siemens SCALANCE XM-400 Configuration Manual

Further notes
You remove the request with the
7.4.2.9

no ipv6 dhcp client request

Description
With this command, you remove the request for the configuration parameter.
Requirement
● DHCPv6 Is activated.
● IPv6 is activated
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
no ipv6 dhcp client request {dns-server-address | domain-name | sntp-server-address |
option <code (1-100)>}
The parameters have the following meaning:
Parameter
dns-server-
address
domain-name
sntp-server-
address
option
code
Result
The required configuration parameter is removed.
Further notes
You configure the request with the
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
no ipv6 dhcp client request
Description
IPv6 address of the DNS server
Domain name
IPv6 address of the SNTP server
Keyword for the option code
ID of the DHCPV6 option
ipv6 dhcp client request
Network protocols
7.4 DHCPv6 client (IPv6)
command.
Range of values / note
-
-
-
-
Specify the required ID of the
DHCPv6 option.
1 ... 100
command.
319