No Switchport Ingress-Filter - Siemens SCALANCE XM-400 Configuration Manual

Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
switchport ingress-filter
Result
The ingress filter is activated.
Further notes
You disable the filter with the
You can display the status of the ingress filter and other settings with the
config
10.2.2.2

no switchport ingress-filter

Description
With this command, you disable the ingress filter.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no switchport ingress-filter
Result
The ingress filter is deactivated.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
no switchport ingress-filter
command.
Load control
10.2 Static MAC filtering
command.
show vlan port
661