Show Interface Mtu; Show Interfaces - Siemens SCALANCE XM-400 Configuration Manual

Configuration
3.1 System
3.1.1.6

show interface mtu

Description
With this command, you show the setting for the Maximum Transmission Unit (MTU) of the
interfaces on the device.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show interface mtu [{vlan<vlan-id(1-4094)>|
The parameters have the following meaning:
Parameter
vlan
vlan-id
port-channel
port-channel-id
interface-type
interface-id
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
If no parameters are specified, the settings for all interfaces are displayed.
Result
The settings for the maximum transmission unit (MTU) of interfaces are displayed.
3.1.1.7

show interfaces

Description
This command shows the status and the configuration of one, several or all interfaces.
60
or
cli#
port-channel<port-channel-id(1-8)>|
<interface-type><interface-id>}]
Description
Keyword for a VLAN connection
Number of the addressed VLAN
Keyword for a port channel connection
Number of the addressed port channel
Type of interface
Module no. and port no. of the interface
Range of values / note
-
1 ... 4094
-
1 ... 8
Enter a valid interface.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10