No Match Tag - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.8 Route maps (IPv4 / IPv6)
Syntax
Call up the command with the following parameters:
match tag <value (1-0xffffff)>
The parameter has the following meaning:
Parameter
value
Result
The filter for a tag is created.
Further notes
You delete the filter for a tag with the
You change to the Route maps configuration mode with the command
You display the setting and other information with the
9.8.3.18

no match tag

Description
With this command, you delete the filter for a tag.
Note
This command is available only with layer 3.
Requirement
You are now in the Route maps configuration mode.
The command prompt is as follows:
cli(config-rmap-$$$)#
644
Description
Value of the tag
Range of values / note
1 ... 0xffffff
You can enter the value in decimal or
hexadecimal.
command.
no match tag
show route-map
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
.
route-map
command.