Passive-Interface; No Passive-Interface - Siemens SCALANCE XM-400 Configuration Manual

9.3.3.12

passive-interface

Description
With this command, you specify that the OSPFv3 interfaces are inactive, that are configured
afterwards.
Note
This command is available only with layer 3.
Requirement
You are in the OSPFv3 router configuration mode.
The command prompt is as follows:
cli(config-ospfv3)#
Syntax
Call the command without parameter assignment:
passive-interface
Result
The configuration is active.
Further notes
You disable the configuration with the no passive-interface command.
You can display the status of this function and other information with the
interface
9.3.3.13

no passive-interface

Description
With this command, you specify that the OSPFv3 interfaces are active, that are configured
afterwards.
Note
This command is available only with layer 3.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
command.
Layer 3 functions
9.3 OSPFv3 (IPv6)
show ipv6 ospf
525