Commands In The Global Configuration Mode; Interface Range - Siemens SCALANCE XM-400 Configuration Manual

Syntax
Call the command without parameter assignment:
show vlan protocols-group
Result
The table of protocol groups is displayed.
6.1.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
6.1.2.1

interface range

Description
With this command, you can put several interfaces or the interfaces of VLANs together and
configure them together. The configurations are valid for all interfaces of the specified range.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
command to change to this mode.
configure terminal
or
end exit
Network structures
command and are then in the
6.1 VLAN
177