Show Pnio - Siemens SCALANCE XM-400 Configuration Manual

Industrial ethernet switches

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

Configuration

Call up the command with the following parameters:

show ipv6 interface [{vlan <id> | <interface-type> <interface-id>} [prefix]]

The parameters have the following meaning:

interface-id

For information on names of addresses and interfaces, refer to the section "Interface

identifiers and addresses (Page 39)".

If you do not select any parameter from the parameter list, the configuration is displayed for

all available IPv6 interfaces.

The configuration is displayed.

Further notes

You enable IPv6 on the VLAN interface or on the router port with the

You configure an IPv6 address with the

show pnio

This command shows the current PROFINET IO configuration.

You are in the User EXEC mode or in the Privileged EXEC mode.

The command prompt is as follows:

Keyword for a VLAN connection

Number of the addressed VLAN

Type or speed of the interface

Module no. and port no. of the interface

shows the prefix information of the IPv6 interface

ipv6 address

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 11/2015, C79000-G8976-C252-10

Range of values / note

Enter a valid interface

Show Quick Links

Table of Contents

Scalance xr-500