Ip Access-List; No Ip Access-List - Siemens SCALANCE XM-400 Configuration Manual

Security and authentication
11.4 IP access control list
11.4.2.1

ip access-list

Description
With this command, you generate a MAC access control list and change to the ACL standard
configuration mode.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ip access-list standard<access-list-number(1-128)
The parameters have the following meaning:
Parameter
standard
access-list-number
Result
The access control list has been generated.
You are in the ACL Standard configuration mode.
The command prompt is:
cli(config-std-nacl)#
Further notes
You delete the IP access control list with the
You exit the ACL Standard configuration mode with the
You display the configuration of the access control list with the
11.4.2.2

no ip access-list

Description
With this command, you delete an IP access control list.
708
Description
Specifies that a standard access con-
trol list is generated
Number of the standard access control
list
no ip access-list
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
>
Range of values / note
-
1 ... 128
command.
command.
exit
show access-lists
Configuration Manual, 11/2015, C79000-G8976-C252-10
command.