No Spanning-Tree Layer2-Gateway-Port; Spanning-Tree Loop-Guard - Siemens SCALANCE XM-400 Configuration Manual

Further notes
You delete the configuration of a port as a layer 2 gateway port with the command
spanning-tree layer2-gateway-port
You can display other information with the
detail
6.3.5.11

no spanning-tree layer2-gateway-port

Description
With this command, you delete the configuration of the port as a layer 2 gateway port.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no spanning-tree layer2-gateway-port
Result
The configuration of the port as a layer 2 gateway port is deleted.
Further notes
You configure a port as a layer 2 gateway port with the command
gateway-port
You can display other information with the
detail
6.3.5.12

spanning-tree loop-guard

Description
This function prevents alternative ports or root ports becoming designated ports if there is a
disruption of a one-way link.
With this command, you enable the function.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
option.
.
option.
.
show spanning-tree interface
show spanning-tree interface
Network structures
6.3 Spanning Tree
no
command with the
spanning-tree layer2-
command with the
243