Commands In The Interface Configuration Mode; Introductory Sentence For The Interface Configuration Mode; Poe Active - Siemens SCALANCE XM-400 Configuration Manual

Syntax
Call the command without parameter assignment:
no poe pse usage
Result
The parameter "Usage Threshold" is set to 80%.
3.5.3

Commands in the Interface Configuration mode

3.5.3.1

Introductory sentence for the interface configuration mode

This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
Global configuration mode.
● If you exit the Interface configuration mode with the
Privileged EXEC mode.
Note
The interface is a Gigabit Ethernet interface.
3.5.3.2

poe active

Description
With this command, you activate PoE for the interface in whose interface configuration mode
you are currently working.
Requirement
You are in the Interface Configuration mode of a PoE interface.
The command prompt is as follows:
cli(config-if-Gi$-$)#
The placeholders $-$ stand for the numbering of the interface.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
command to change to this mode.
interface
command, you return to the
exit
command, you return to the
end
Configuration
3.5 PoE
123