No Vrrp Primary-Ip - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.5 VRRPv3 (IPv4 / IPv6)
Syntax
Call up the command with the following parameters:
vrrp <vrid(1-255)> primary-ip [{ ipv4 <ip_addr> | ipv6 <ip6_addr> }]
The parameters have the following meaning:
Parameter
vrid
ipv4
ip_addr
ipv6
ip6_addr
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
Result
The primary IP address is specified.
Further notes
You configure a VRRP3 interface with the
You remove the primary IP address with the
You show the configuration of the virtual router with the
command.
9.5.5.10

no vrrp primary-ip

Description
With this command, you remove a primary IP address from the virtual router.
Note
This command is available only with layer 3.
Requirement
You are in the VRRP3 Interface configuration mode.
The command prompt is as follows:
cli(config-vrrp-v3-if-$$$)#
586
Description
ID of the virtual router
Keyword for IPv4 address
IPv4 address
Keyword for IPv6 address
IPv6 address
interface
no vrrp pirmary-ip
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Range of values / note
1 ... 255
-
Enter a valid IPv4 address.
-
Enter a valid IPv6 address.
command.
command.
show vrrp3 interface - vrid
Configuration Manual, 11/2015, C79000-G8976-C252-10