Syntax
Call up the command with the following parameters:
route-map <name(1-20)> [ <seqnum(1-10)> ]
The parameters have the following meaning:
Parameter
name
seqnum
Result
The route map has been deleted.
Further notes
You create a route map and change to the Route maps configuration mode with the
command
You display the setting and other information with the
9.8.3
Commands in the Route maps configuration mode
This section describes commands that you can call up in the Route maps configuration
mode.
In the global configuration mode, enter the
● If you exit the Route maps configuration mode with the
global configuration mode.
● If you exit the Route maps Configuration mode with the
Privileged EXEC mode.
9.8.3.1
match destination ip
Description
With this command, you specify whether or not the routing information for a route map is
filtered based on the destination IPv4 address.
Note
This command is available only with layer 3 (IPv4).
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
Description
Name of the route map
Sequence number of the route map
.
route-map
9.8 Route maps (IPv4 / IPv6)
Range of values / note
0 ... 20
1 ... 10
show route-map
command to change to this mode.
route-map
command, you return to the
exit
command, you return to the
end
Layer 3 functions
command.
627