Match Interface - Siemens SCALANCE XM-400 Configuration Manual

Syntax
Call up the command with the following parameters:
no match destination ipv6 <IPv6 address> <Prefix Length>
The parameters have the following meaning:
Parameter
IPv6 address
Prefix Length
Result
The filter for the destination IPv6 address is deleted.
Further notes
You create a filter for the destination IPv6 address with the
command.
You create a filter for the destination IPv4 address with the
You change to the Route maps configuration mode with the command
You display the setting and other information with the
9.8.3.5

match interface

Description
With this command, you specify whether or not the routing information for a route map is
filtered based on the interface.
Note
This command is available only with layer 3.
Requirement
You are now in the Route maps configuration mode.
The command prompt is as follows:
cli(config-rmap-$$$)#
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
Description
IPv6 address
Decimal representation of the mask
as a number of "1" bits
Range of values / note
Enter the IPv6 address of the destination on which the filter-
ing is based.
0 ... 128
Enter the mask of the destination on which the filtering is
based.
match destination ipv6
match destination ip
show route-map
Layer 3 functions
9.8 Route maps (IPv4 / IPv6)
command.
.
route-map
command.
631