The "Show" Commands; Show Ptp Info; Commands In The Global Configuration Mode - Siemens SCALANCE XM-400 Configuration Manual

System time
5.4 PTP Client
5.4.1

The "show" commands

This section describes commands with which you display various settings.
5.4.1.1

show ptp info

Description
This command shows the current settings for the Precision Time Protocol (PTP).
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show ptp info [ interfaces <interface-type> <interface-id> ]
The parameters have the following meaning:
Parameter
interfaces
interface-type
interface-id
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
Result
The current settings for the Precision Time Protocol (PTP) are displayed.
5.4.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
162
or
cli#
Description
Keyword for a an interface name.
Type or speed of the interface.
Slot no. and port no. of the interface.
command to change to this mode.
configure terminal
or
end exit
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
Range of values / note
-
Enter a valid interface name.
command and are then in the