Siemens SCALANCE XM-400 Configuration Manual page 512

Layer 3 functions
9.3 OSPFv3 (IPv6)
Requirement
You are in the OSPFv3 router configuration mode.
The command prompt is as follows:
cli(config-ospfv3)#
Syntax
Call up the command with the following parameters:
no area <area-id>
[ {
{range {summary | Type7} | summary-prefix}
<IPv6-Prefix> <Prefix-Length>
} ]
The parameters have the following meaning:
Parameter Description
area-id
Area ID
stub
Stub area
nssa
NSSA
virtual-link
Virtual link
router-id
ID of the router
default-metric
Metric of the standard route
range
Address range
summary
LSA type 3
Type7
LSA type 7
summary-prefix
Address range of external
routes
IPv6-Prefix
IPv6 address
Prefix-Length
Number of bits belonging to the
prefix
(from left to right)
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
Result
The area is removed or changed.
512
stub | nssa | virtual-link <router-id> |default-metric |
Range of values / note
Specify the ID in the IPv4 address format
x.x.x.x = 0 ... 255
The area ID 0.0.0.0 is reserved for the backbone area and cannot be
deleted.
-
-
-
Specify the ID in the IPv4 address format
x.x.x.x = 0 ... 255
-
-
-
-
-
Enter a valid IPv6 address
1 ... 128 bits
128: The node (host) itself
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10