Cabletest Interface - Siemens SCALANCE XM-400 Configuration Manual

Diagnostics
12.1 Event and fault handling
Result
You are now in the EVENTS configuration mode.
The command prompt is as follows:
cli(config-events)#
Further notes
You exit the EVENTS configuration mode with the command
12.1.5.2

cabletest interface

Description
With this command, you enable the cable test for the specified interface.
Note
Wire pairs
Wire pairs 4-5 and 7-8 of 10/100 Mbps network cables are not used.
The wire pair assignment - pin assignment is as follows (DIN 50173):
Pair 1 = pin 1-2
Pair 2 = pin 3-6
Pair 3 = pin 4-5
Pair 4 = pin 7-8
Requirement
● The interface has no active data traffic.
● You are in the Global configuration mode.
The command prompt is:
cli(config)#
766
or
end exit
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
.