No Unicast-Block; Load And Save - Siemens SCALANCE XM-400 Configuration Manual

Further notes
You disable the blocking of unicast frames with the
You display the status of this function with
3.1.13.21

no unicast-block

Description
With this command, you disable the blocking of unknown unicast frames on an interface.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameter assignment:
no unicast-block
Result
The blocking of unicast frames is disabled.
Further notes
You enable the blocking of unicast frames with the
You display the status of this function with
3.2

Load and Save

This section describes commands for displaying, copying, saving and downloading files for
the device.
Note
Note that during the installation of a previous version, the configuration data can be lost. In
this case, the device starts up with the factory configuration settings after the firmware has
been installed.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
no unicast-block
show unicast-block config
unicast-block
show unicast-block config
Configuration
3.2 Load and Save
command.
.
command.
.
101