Dynamic Mac Aging; The "Show" Commands; Show Mac-Address-Table Aging-Time - Siemens SCALANCE XM-400 Configuration Manual

Load control

10.3 Dynamic MAC aging

Further notes
You enable the filter with the
You can display the status of the ingress filter and other settings with the
config
10.3 Dynamic MAC aging
The section describes commands with which the aging of dynamically learned entries is
configured in a MAC address list.
10.3.1

The "show" commands

This section describes commands with which you display various settings.
10.3.1.1

show mac-address-table aging-time

Description
To ensure that the address entries are up-to-date, MAC addresses are only kept in the
address table for a specified time.
This command shows the time after which the MAC addresses are removed from the
address table.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameters:
show mac-address-table aging-time
Result
The time is displayed.
662
command.
or
cli#
switchport ingress-filter
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
command.
show vlan port