Syntax
Call the command without parameters:
show pnio
Result
The current PROFINET IO configuration is displayed.
3.1.1.12
show broadcast-block config
Description
This command shows the broadcast blocking settings for ports.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show broadcast-block config [port <interface-type> <interface-id)>]
The parameters have the following meaning:
Parameter
port
interface-type
interface-id
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
Result
The broadcast blocking settings for ports are displayed.
3.1.1.13
show unicast-block config
Description
This command shows the unicast blocking settings for ports.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
or
cli#
Description
Keyword for a port description
Type or speed of the interface
Module no. and port no. of the interface
Configuration
3.1 System
Range of values / note
-
Enter a valid interface.
65