Configuration Limits - Siemens SCALANCE XM-400 Configuration Manual

Description

2.3 Configuration limits

Privileged EXEC mode
You change to this mode if you log in with the name "admin" or enter the command
User EXEC mode. There are two ways of exiting the Privileged EXEC mode:
1. The
2. The
User EXEC mode. (The
Global configuration mode
In this mode, you can make basic configuration settings. In addition to this, you can also call
up modes for the configuration of special interfaces or functions, for example to configure a
VLAN or a C-PLUG. You change to this mode by entering
Privileged EXEC mode. To exit this mode, enter
Other configuration modes
From the Global configuration mode, you can change to other configuration modes for
special tasks. These are either general configuration modes (for example line configuration,
interface configuration) or protocol-specific configuration modes (SNTP, NTP).
2.3 Configuration limits
Configuration limits of the device
The following table lists the configuration limits for Web Based Management and the
Command Line Interface of the device.
The usability of various functions depends on the device type you are using and whether or
not a KEY-PLUG is inserted.
System
Layer 2
34
command logs you out; the Login Prompt prompt appears.
exit
command brings you back one level from the Privileged EXEC mode to the
disable
disable
Configurable function
Syslog server
E-mail server
SNMPv1 trap recipient
SNTP server
NTP server
Virtual LANs (port-based; including VLAN 1)
Protocol-based VLAN groups
Protocol-based VLAN groups per port
IPv4 subnet-based VLANs
Multiple Spanning Tree instances
Link aggregations or Etherchannels each with a maximum of 8
ports per aggregation
Ports in a link aggregation
command is not available in the User EXEC mode.)
configure terminal
.
end
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
in
enable
in the
Maximum number
3
3
10
1
1
257
12
12
150
16
8
8