Commands In The Ripv2 Router Configuration Mode; Note_On_Layer 3; Auto-Summary - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.6 RIPv2 (IPv4)
Result
Routing with RIP is disabled.
Further notes
You enable the RIP protocol with the
9.6.3

Commands in the RIPv2 Router configuration mode

This section describes commands that you can call up in the RIPv2 Router configuration
mode.
In the Global configuration mode, enter the
● If you exit the RIPv2 Router configuration mode with the
Global configuration mode.
● If you exit the RIPv2 Router configuration mode with the
Privileged EXEC mode.
9.6.3.1

Note_on_layer 3

Note
These commands are available only with layer 3.
9.6.3.2

auto-summary

Description
This command automatically summarizes routing information according to IP classes. When
possible, subnets are summarized according to classes (A, B or C) and entered as single
routes. As default, this function is enabled.
Requirement
You are in the RIPv2 Router configuration mode.
The command prompt is as follows:
cli(config-rip)#
Syntax
Call the command without parameter assignment:
auto-summary
594
command.
router rip
command to change to this mode.
router rip
exit
end
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
command, you return to the
command, you return to the