Layer 3 functions
9.4 VRRPv2 (IPv4)
9.3.4.18
no ipv6 ospf transmit-delay
Description
With this command, you reset the interval to the default value.
Note
This command is available only with layer 3.
Requirement
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameter assignment:
no ipv6 ospf transmit-delay
Result
The interval is reset.
Further notes
You enable OSPFv3 routing with the
You configure the interval with the
You enable OSPFv3 routing with the
9.4
VRRPv2 (IPv4)
This section describes the commands relevant for working with routing with VRRP.
Note
• The commands are only available with layer 3 and only in conjunction with VLAN
interfaces. Router ports are not supported
• Enable routing to be able to use VRRP.
• VRRP supports only IPv4. If you want to use IPv4 and IPv6, use VRRPv3
548
command.
ipv6 router ospf
ipv6 ospf transmit-delay
command.
ipv6 router ospf
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
command.