Ipv6 Ospf Transmit-Delay - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.3 OSPFv3 (IPv6)
Requirement
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameter assignment:
no ipv6 ospf retransmit-interval
Result
The interval is reset.
Further notes
You enable OSPFv3 routing with the
You configure the interval with the
You display the configuration with the
9.3.4.17

ipv6 ospf transmit-delay

Description
With this command you specify the time that a link state update packet requires for
transmission.
Note
This command is available only with layer 3.
Requirement
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
546
command.
ipv6 router ospf
ipv6 ospf retransmit-interval
show ipv6 ospf interface
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
command.
command.