Commands In The Interface Configuration Mode; Mac Access-Group - Siemens SCALANCE XM-400 Configuration Manual

11.3.3

Commands in the interface configuration mode

This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
Global configuration mode.
● If you exit the Interface configuration mode with the
Privileged EXEC mode.
11.3.3.1

mac access-group

Description
With this command, you enable the access control of the packets of an interface.
Requirement
● A MAC access control list has been created.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
mac access-group <access-list-number(1-128)>{in|out}
The parameters have the following meaning:
Parameter
access-list-number
in
out
Result
The packets are filtered according to the access control list (ACL).
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
interface
Description
Number of the access control list
Specifies that incoming packets are
filtered
Specifies that outgoing packets are
filtered
Security and authentication
11.3 MAC access control list
command to change to this mode.
command, you return to the
exit
command, you return to the
end
Range of values / note
1 ... 128
-
-
701