5.3.3.4
no sntp unicast-server
Description
With this command, you delete the attributes for an SNTP unicast server and reset the
address.
Requirement
You are in the SNTP configuration mode.
The command prompt is as follows:
cli(config-sntp)#
Syntax
Call up the command with the following parameters:
no sntp unicast-server {ipv4 <ucast_addr> | fqdn-name <FQDN>}
The parameters have the following meaning:
Parameter
ipv4
ucast_addr
fqdn-name
FQDN
Result
The SNTP unicast server is reset to the default value.
Further notes
You configure the setting with the
You display this setting and other information with the
command.
5.4
PTP Client
The following devices support time-of-day synchronization using PTP:
● SCALANCE XR528-6M
● SCALANCE XR552-12M
This section describes commands relevant for configuration of the Precision Time Protocol
according to IEEE 1588.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
Description
Keyword for an IP address
Value for an IPv4 unicast address
Keyword for a domain name
Domain name (Fully Qualified Domain
Name)
sntp unicast-server
Range of values / note
-
Enter a valid IPv4 unicast address
-
Maximum of 100 characters
command.
show sntp unicast–mode status
System time
5.4 PTP Client
161