Show Interface Transceiver Details - Siemens SCALANCE XM-400 Configuration Manual

Requirement
● The interface has no active data traffic.
● The
configuration mode.
● You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is:
cli>
Syntax
Call up the command with the following parameters:
show cabletest interface <interface-type> <interface-id>
The parameters have the following meaning:
Parameter
interface-type
interface-id
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
Result
The result is displayed.
Further notes
You enable the cable test function with the
configuration mode.
12.1.3.8

show interface transceiver details

Description
This command runs error diagnostics for an SFP port.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
cabletest interface
or
cli#
Description
Type of interface
Interface identifier
or
cli#
function was used on the specified interface in the Global
cabletest interface
Diagnostics
12.1 Event and fault handling
Range of values / note
Enter a valid interface.
command in the Global
763