No Network Area - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.2 OSPFv2 (IPv4)
9.2.3.18

no network area

Description
With this command, you remove the OSPF interface and the Area ID connected to the OSPF
interface.
Note
This command is available only with layer 3.
Requirement
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
Syntax
Call up the command with the following parameters:
no network <network number> area <area-id>
The parameters have the following meaning:
Parameter
network number
area-id
Result
The OSPF interface is removed.
Further notes
You create the OSPF interface and the area with the
You can display the status of this function and other information with the
interface
472
Description
Network number
Area-ID
command.
Range of values / note
Enter a valid network number
enter an ID.
x.x.x.x
x = 0 ... 255
0.0.0.0 = backbone area
command.
network area
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
show ip ospf