Result
The IPv6 address is assigned to the interface.
Further notes
You delete the IPv6 address with the
You enable IPv6 with the
You display this setting and other information with the
You display the IPv6 address of the DHCP PD sub-client with the
interfaces.
You enable prefix delegation with the
You enable stateless DHCPv6 autoconfiguration with the ipv6 address dhcp stateless
command
7.2.4.2
no ipv6 address
Description
With this command, you delete the IPv6 address.
Requirement
● IPv6 is activated
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
ipv6 enable
command.
command.
no ipv6 address
command.
show ipv6 interface
command.
ipv6 address dhcp
Network protocols
7.2 IPv6 protocol
command.
show ipv6 dhcp sub-client
295