No Network; Redistribute - Siemens SCALANCE XM-400 Configuration Manual

Result
RIP is enabled for the specified IP interface.
9.6.3.9

no network

Description
This command disables the RIP protocol for an IP interface.
Requirement
You are in the RIPv2 Router configuration mode.
The command prompt is as follows:
cli(config-rip)#
Syntax
Call up the command with the following parameters:
no network <ip-address>
The parameter has the following meaning:
Parameter
ip-address
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
Result
RIP is disabled for the specified IP interface.
9.6.3.10

redistribute

Description
This command specifies which route information is forwarded by RIP.
Requirement
You are in the RIPv2 Router configuration mode.
The command prompt is as follows:
cli(config-rip)#
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
Description
The IP address for which RIP will be
disabled.
Layer 3 functions
9.6 RIPv2 (IPv4)
Range of values / note
Specify a valid IP address.
599